ā 8 ā
6. NOTE ON ASSEMBLING MECHANICAL DECK
6-1. Application of Grease
1) Grease must be applied if the following parts were replaced.
(See Fig. 8)
Note 1: Recommended grease is Foil KG-70MP.
Note 2: In applying grease, take care not to allow grease to
stick to other parts (particularly, rubber belt, spindle
motor, and optical pick-up)
Base unit holder
2 bosses
Slide base Skew cam
Cam gear
Tray 3 grooves
Note: Add grease if tray
moves slowly.
Loading pulley shaft
Note: Add grease if tray
generates noise
periodically.
Fig. 8
To Next Page
