Sony EV-S900 - Page 52

52
a
Your TV receiver must be adjusted to receive the signal
from your recorder. If you connect a color monitor or a
TV equipped with video/audio input jacks, it does not
need adjusting. :
1 Set RF UNIT at the rear to 3CH or 4CH whichever
channel is not active in your area.
2 Press POWER. The indicator lights.
3 Insert the cassette.
4 Press » PLAY.
5 Tum on the TV.
6 Set the TV to either VHF channel! 3 or 4 to agree with
_ the RF UNIT setting.
The playback picture will be displayed on the TV
screen. If a picture does not appear on the TV screen
or if the display is not clear, fine-tune the channel on
the TV. For details on TV channel adjustment, see the
instruction manual of the TV receiver.
Check!
Check that the display on the screen changes when
you stop the tape by pressing mi STOP on the
recorder. (To eject the cassette, press OPEN/CLOSE.)
If the display does not change, repeat the preceding
steps.
Now your TV receiver is tuned on the recorder. Whenever
you use this VCR, you should set the TV to the channel
which you have chosen above.