EasyManua.ls Logo

Sony HCD-DJ2i - Page 64

Sony HCD-DJ2i
88 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
HCD-DJ2i
64
Pin No. Pin Name I/O Description
54 CD BUS1 O Communication data bus line output for the CD-MP3 processor IC
55 CD BUS2 O Communication data bus line output for the CD-MP3 processor IC
56 CD BUS3 O Communication data bus line output for the CD-MP3 processor IC
57 CD CLK (BUCK) O Serial data transfer clock signal output for the CD-MP3 processor IC
58 CD CCE (CE) O Chip enable control signal output for the CD-MP3 processor IC
59 CD MP3 IREQ I Decoder request signal input from the CD-MP3 processor IC
60 EEPROM DATA O Serial data line output for the EEPROM IC
61 EEPROM CLK O Serial clock line signal output for the EEPROM IC
62 VCC — Power supply pin (+3.3 V)
63 FL-CLK O Serial data transfer clock signal output for the FL display driver IC
64 VSS — Ground
65 FL-RST O Reset signal output for the FL display driver IC
66 FL-CS O Chip select signal output for the FL display driver IC
67 FL-DATA O Serial data output for the FL display driver IC
68 FADER SLIDER I Voltage level detect signal input from the CROSS FADER variable resistor (A/D input)
69 MULTI JOG 1 I Jog dial pulse detect signal input from the multi jog dial A (A/D input)
70 MULTI JOG 2 I Jog dial pulse detect signal input from the multi jog dial B (A/D input)
71 EQ HIGH JOG I Jog dial pulse detect signal input from the HIGH jog dial (A/D input)
72 EQ MID JOG I Jog dial pulse detect signal input from the MID jog dial (A/D input)
73 IPOD2 DET I iPod 2 status detect signal input from the iPod 2 connector
74 POWER/DISPLAY-KEY I Power and display keys press detect signal input (interrupt input)
75 ST-RDS-INT I RDS data transfer clock signal input from the tuner pack (FM/AM) (AEP, UK model)
76 ST-RDS-DATA I RDS data input from the tuner pack (FM/AM) (AEP, UK model)
77 I2C-DATA I/O Two-way serial data input/output (Fixed at H in this set)
78 I2C-CLK I/O Two-way serial data transfer clock signal input/output (Fixed at H in this set)
79 LED POWER O Switch LEDs drive signal output (H: LED ON)
80 AD SUPPLY SW O Power ON/OFF control signal output for the jog dial
81 EQ LOW JOG I Jog dial pulse detect signal input from the LOW jog dial (A/D input)
82 HP VOL I Voltage level detect signal input from the headphone level variable resistor (A/D input)
83 MASTER VOL I Jog dial pulse detect signal input from the VOLUME encoder (A/D input)
84 AD-KEY2 I Key signal input from the AD key line 2
85 AD-KEY1 I Key signal input from the AD key line 1
86 AD-KEY0 I Key signal input from the AD key line 0
87 LED-LATCH O Serial latch control signal output for the LED driver IC
88 LED-DATA O Serial data output for the LED driver IC
89 LED-CLK O Serial data transfer clock signal output for the LED driver IC
90 POWER ILL I Power illuninator LED drive signal input from the electronic volume IC (A/D input)
91 DEST IN I Destination setting signal input (A/D input)
92 CHN 1 LVL I Channel A level detect signal input (A/D input)
93 CHN 2 LVL I Channel B level detect signal input (A/D input)
94 VACS IN/ P ILL I VACS level detect signal input from the electronic volume IC (A/D input)
95 OVERVOLTAGE I Over-voltage protect detect signal input (L: over-voltage detect) (A/D input)
96 AVSS — Ground
97 ST-DOUT O PLL serial data output for the tuner pack (FM/AM)
98 AVREF — Reference voltage input (+3.3 V)
99 AVCC — Power supply pin (+3.3 V)
100 ST-CLK O PLL serial data transfer clock signal output for the tuner pack (FM/AM)

Table of Contents