Sony HR TRINITRON PVM-8045Q - 3 Set-Up Adjustments; Preparations

3-1
S MIC Chassis
SECTION 3
SET-UP ADJUSTMENTS
3-1. PREPARATIONS
The following adjustments should be made when a
complete realignment is required or a new picture tube is
installed. These adjustments should be performed with
rated power supply voltage unless otherwise noted.
The controls and selectors below should be set as follows
unless otherwise noted.
Front Panel Controls
VOLUME control.......................... 50 %
CONTR control ............................. 80 %
PHASE control .............................. 50 % (center click)
CHROMA control ......................... 50 % (center click)
BRIGHT control ............................ 50 % (center click)
APER control................................. 50 % (center click)
Front Panel Selectors
SYNC INT/EXT selector .............. Pull (INT)
LINE/RGB selector ....................... Pull (LINE)
A/B, RGB/Y R-Y B-Y selector ..... Pull (RGB)
BLUE ONLY selector ................... Pull (OFF)
UNDER SCAN selector ................ Pull (OFF)
H/V DELAY selector .................... Pull (OFF)
16 : 9 selector................................. Pull (4 : 3)
Rear Panel Control
V HOLD control ............................ Stable position
Perform the adjustment in order as follows:
3-2. Landing Adjustment
3-3. Convergence Adjustment
3-4. Focus Adjustment
3-5. White Balance Adjustment