Sony KDF-46E2000 - Exiting Service Mode; Service Menus; Verifying Service Data Changes; Resetting Wega (User) Menu to Factory Defaults

KDF-46E2000/46E2010/50E2000/50E2010/55E2000/55E2010
KDF-46E2000/46E2010/50E2000/50E2010/55E2000/55E2010
51
SERVICE MENUS
(CATEGORIES ONLY)
TV MICRO TV MICRO (cont.) Q BO
X
VERSION IRIS_DBC
QM
ID IRIS_ADJ
QT
NVM_SEL IRIS_UFOFS
MODEL IRIS_WBOFS
OSD IRIS_SCSB
CCD IRIS_FIXED
CCT DSP_STEP
OPTIONS DSP_SURR
CXA2229Q DSP_MIXR
USER_NR
DSP_AGC
LPF_1 DSP_BT
SNNR DSP_BBE
SNSS DSP_DRC
CCPM_1 DSP_BQ
CCPM_2 FAN_CTRL
CCPM_3 TEMP_SRV
CCPM_4 TEMP_BRTO
CCPM_5 PAWN_3DG
CCPM_6 PAWN_SYS
CCPM_7 PAWN_CAP
CCPM_8 PAWN_MUT
CCPM_9 PAWN_PIC
CCPM_10 PAWN_BLK
CCPM_11 PAWN_WBO
CCPM_12 PAWN_TSP
HELIOS_1
PAWN_CUR
HELIOS_2
PAWN_TIM
HELIOS_3
PAWN_HPF
HELIOS_4
IRIS_APL
HELIOS_5
TIME
SCREEN IMG_SHIFT
DCP_INT HDMI
DCP_OSD
DCP_BLK
DCP_ADJ1
DCP_ADJ2
DCP_USER
DCP_AVP
A7001R
A7001G
A7001B
A7007R
A7007G
A7007B
A7007RGB
2-4-1. EXITING SERVICE MODE
After completing the changes, exit service mode by turning off the set
using the Remote Commander or the power switch.
NOTE: After exiting service mode wait 2 minutes before restarting
the set to allow the fans to shut down properly.
2-5. VERIFYING SERVICE DATA CHANGES
1. After completing all adjustments turn the set off with the Remote
Commander and WAIT for the fans to turn off before proceeding to
the next step.
Note: It may take up to two minutes for the fans to stop.
Caution: To avoid over heating the lamp, do not unplug the set
until the fans have stopped.
2. After the fans have stopped, unplug the set from the AC outlet, then
plug the set back in the AC outlet.
3. To verify the changes repeat steps 1 through 3 of 2-4. Using the
Remote Commander to Change Service Data.
4. To exit service mode, turn the power off by pressing
POWER
.
Wait 2 minutes before restarting the set to allow the fans to
completely shut down or the Service Menu will appear on the screen.
NOTE: After exiting service mode wait 2 minutes before restarting
the set to allow the fans to shut down properly.
2-6. RESETTING WEGA (USER) MENU TO
FACTORY DEFAULTS
Use the following instructions to restore the User Controls and
Channel Memory settings to the preset factory conditions.
1. Turn the TV on by press
POWER
on the Remote Commander.
2. While holding down the
on the Remote Commander, press the
POWER button on the Front Panel of the set.
The set restarts and displays the initial setup screen. This may take
several minutes.