Procedure
1. Release the fan harness from the harness clamp and disconnect the fan harness from the connector CN3300 on the
MIX-54 board.
2. Remove the two screws to detach the fan assembly.
B4 x 30
CN3300 (MIX-54 board)
Fan harness
Fan harness
Fan assembly
Clamp
3. Release the fan harness from the harness lock to detach the DC fan (80 square).
Harness lock
Fan harness
DC fan (80 square)
Label
4. Install the removed parts by reversing the steps of removal.
Note
Pay attention to the orientation of the DC fan (80 square) when installing it.
1-3-4. LCD Module
Preparation
1. Remove the top panel assembly. (Refer to “1-3-1. Top Panel Assembly”.)
2. Remove the KY-671 board. (Refer to “1-3-9. KY-671 Board”.)
MCS-8M
1-16
To Next Page
Loading...
