1-5. Message List
When a problem occurs on the unit during operation, the following types of messages appear. For some of them, only
ID is displayed without a message.
Message example:
0001
Rate
30
SS
Mon
PGM
File
4203
Select
USB memory is not recognized.
Confirm the USB memory.
Enter
Message type
Message ID
Message
The following message types exist.
Error Massages
(Error):
Starts with "4". (4xxx)
Indicates an inability to continue operation, malfunction, or other severe error.
Warning Massages
(Warning):
Starts with "3" (3xxx)
Indicates that problems may occur if you continue operation.
Information Messages
(Information):
Starts with "1". (1xxx)
Indicates a notification.
Errors
ID Message Solution
4001 An internal fan is stopped.
Please turn off the system immediate-
ly.
Replace the fan unit.
4002 The temperature in the system is ris-
ing.
Please turn off the system immediate-
ly.
Check the intake air vent and exhaust air vent to see if air flow is blocked. If
the filter is clogged, clean it. If the fan is defective, replace the fan unit.
4003 Unable to start.
Please restart.
Check the connection between the CN-3403 board (audio input/output board)
and the MIX-54 board, and reconnect the cable correctly, if necessary. In case
the error still remains despite correct cable connection, replace the cable.
4004 Unable to start.
Please restart.
Check the connection between the CN-3404 board (analog video input/output
board) and the MIX-54 board, and reconnect the cable correctly, if necessary.
In case the error still remains despite correct cable connection, replace the
cable.
4005 Unable to start.
Please restart.
The video/audio signal processor device is not working correctly. Reinstall
the firmware. In case the error still remains despite correct firmware installa-
tion, replace the MIX-54 board.
Continued
MCS-8M
1-30
To Next Page
Loading...
