ID Message Solution
4201 Loading configuration file error. The selected configuration file may not be an MCS-8M supported file, or it
may be damaged.
4202 Saving configuration file error.
Please retry.
The configuration file could not be saved. The USB flash drive may be mal-
functioning or may not be supported.
4203 USB memory is not recognized.
Confirm the USB memory.
Check whether operation has been verified with the respective USB flash drive
model. If operation has been verified, the USB flash drive may be damaged.
4204 Formatting USB memory error.
Please retry.
4205 Reading folder/file error.
Confirm the folder/file.
4206 Making folder/file error.
Please retry.
4207 Importing error.Please retry.
4208 Exporting error.Please retry.
4209 More than 99 files exist in the folder. Use a computer or other device to delete unnecessary files from the folder so
that the number of files does not exceed 99.
4210 No file in the folder.
Confirm the folder.
Files do not exist in the folder on the USB flash drive used as the import source.
Check the folder on the USB flash drive.
4211 No data to export.
Confirm the source.
The data specified for export does not exist on the unit. Check that the frame
memory, snapshot, or other data specified for export has been created.
4212 Importing error.
Unsupported format.
Check the requirements for TGA, TIFF, and BMP files that can be imported.
[See "Importing and Exporting Images" at "Operating Instructions"]
Warnings
ID Message Solution
3001 No reference signal input state detec-
ted.
Please confirm that the reference ca-
ble is properly configured.
Reference signal input does not exist, although the input reference signal is
set to [BB] or [Tri].
Set [System Reference] to [INT], or connect the appropriate reference signal.
See "Details" on [System] menu at "Operation Instructions"
3002 Reference signal unlock state detec-
ted.
Please confirm that the reference ca-
ble is properly configured.
The frequency of the reference signal input does not match that of the system
format, or it is not locked. Check the reference signal input.
See "Details" on [System] menu at "Operation Instructions"
3003 Signal Format of HDMI IN 1 is dif-
ferent from the setting.
Please match the signal format to the
system format.
The input signal format of the HDMI IN 1 connector does not match that of
the system format. Match the signal to the system format.
3004 Signal Format of HDMI IN 2 is dif-
ferent from the setting.
Please match the signal format to the
system format.
The input signal format of the HDMI IN 2 connector does not match that of
the system format. Match the signal to the system format.
3005 Signal Format of HDMI IN 3 is dif-
ferent from the setting.
Please match the signal format to the
system format.
The input signal format of the HDMI IN 3 connector does not match that of
the system format. Match the signal to the system format.
Information
ID Message Solution
1101 The setting is changed.
Perform "Startup Define", and then
restart.
This appears when you change the system format or 3D mode, or when the
system otherwise needs to be restarted. Execute [Startup Define], and restart
the unit.
Continued
MCS-8M
1-31
To Next Page
Loading...
