Sony MCS-8M - Pointer; Dust Protection Sheet

Procedure
1. Release the claws of the battery holder to detach the lithium battery from the MIX-54 board.
Lithium battery
“+” mark face
Claws
Battery holder
MIX-54 board
2. Install the removed parts by reversing the steps of removal.
Note
Install the lithium battery with the + side facing up.
1-3-12. Pointer
Preparation
1. Remove the top panel assembly. (Refer to “1-3-1. Top Panel Assembly”.)
2. Remove the KY-671 board. (Refer to “1-3-9. KY-671 Board”.)
Procedure
1. Remove the two screws to detach the WP clamp and the pointer.
Pointer
WP clamp
PSW3 x 8
2. Install the removed parts by reversing the steps of removal.
1-3-13. Dust Protection Sheet
Preparation
1. Remove the top panel assembly. (Refer to “1-3-1. Top Panel Assembly”.)
2. Remove the insulation sheet (PS). (Refer to “1-3-2. Switching Regulator”.)
MCS-8M
1-25