Sony MCS-8M - Page 42

9. Upon completion of the installation, a message (ID: 1102) appears in the item area. Confirm that all modules have
been successfully installed. If an error is present, retry installation from step 5.
0001
Rate
30
SS
Mon
PGM
Install
1102
Finished. Please restart.
M:%s/B:%s/F:%s/R:%s/Font:%s
FPGA1:%s/2:%s/3:%s/4:%s
The following items are displayed.
M: Main application program
B: Boot program
F: Firmware for image processor
R: Register for image processor
Font: Font data for menu display
FPGA1: Configuration data for video processing device (FS1)
FPGA2: Configuration data for video processing device (FS2)
FPGA3: Configuration data for video processing device (XPT)
FPGA4: Configuration data for audio processing device
%s: "O": OK
"E": Error
"-": Not installed
Note
• While menu display font data is being installed, the menu display becomes all blue but this is not a problem.
• All operations are displayed during installation.
• Once installation starts, it cannot be interrupted.
10. Press the [V3] knob.
11. Turn off the power of the unit.
12. Disconnect the USB memory from the USB connector of the unit.
Checking after installation
1. Turn on the power of the unit.
2. Confirm that the unit is working normally.
3. Press the SETUP button beside the menu display of the unit.
4. Select "Information" (last of the item list) with the adjustment [V1] knob and press the [V1] knob.
5. Versions of the installed modules are displayed on the menu display.
6. Confirm that the versions of target modules are correct.
Backing up boot program data
1. Press the SETUP button beside the menu display of the unit.
2. Select "System" with the [V1] knob and press the [V1] knob.
3. Move the cursor to "Back" at the bottom of the item list with the [V1] knob.
4. Press the [V3] knob.
5. The "For Services" menu dedicated to service is displayed.
6. Select "Boot Flash Backup" with the adjustment [V1] knob.
7. Press the [V4] knob to start backup of the boot program.
8. Wait for about 30 seconds. Panel operations are disabled during this time period.
Note
Do not turn off the power until the backup is completed.
9. After about 30 seconds have passed, confirm that panel operations are enabled. Enabled panel operation shows
that the backup has been completed.
MCS-8M
1-34