25
GB
MHC-V5.GB.4-531-350-11(1)
BLUETOOTH
Pairing this system with a
BLUETOOTH device
Pairing is an operation where
BLUETOOTH devices register with
each other beforehand. Once a
pairing operation is performed, it
does not need to be performed
again. If your device is an NFC-
compatible smartphone, the manual
pairing procedure is not necessary.
1 Place the BLUETOOTH device
within 1meter (3 feet) from the
system.
2 Press BLUETOOTH on the unit to
select the BLUETOOTH function.
“BLUETOOTH” appears on the
display.
Note
If the system is connected to a
BLUETOOTH device, press BLUETOOTH
to disconnect the BLUETOOTH device.
3 Hold down BLUETOOTH on the
unit for 2seconds or more.
“PAIRING” flashes on the display.
4 Perform the pairing procedure
on the BLUETOOTH device.
For details, refer to the operating
instructions of your BLUETOOTH
device.
5 Select the model number of the
unit on the display of the
BLUETOOTH device.
For example, select “SONY:MHC-V5.”
If passkey is required on the
BLUETOOTH device, enter “0000”.
6 Perform the BLUETOOTH
connection on the BLUETOOTH
device.
When pairing is completed and the
BLUETOOTH connection is
established, BLUETOOTH device
name appears on the display.
Depending on the BLUETOOTH
device, connection may start
automatically after pairing is
completed.
You can check the BLUETOOTH
device address by pressing DISPLAY
repeatedly.
Notes
ˎ
You can pair up to 9 BLUETOOTH
devices. If the 10th BLUETOOTH device
is paired, the oldest paired device will
be deleted.
ˎ
“Passkey” may be called “Passcode,”
“PIN code,” “PIN number” or “Password,”
etc., depending on the device.
ˎ
The pairing standby status of the
system is canceled after about 5
minutes. If pairing is not successful,
repeat from step 1.
ˎ
If you want to pair with another
BLUETOOTH device, repeat steps 1 to 6.
To cancel the pairing operation
Hold down BLUETOOTH on the
unit for 2seconds or more until
“BLUETOOTH” appears on the
display.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
