Assigning Functions to Assignable Switches
141
Chapter 6 Menu and Detailed Settings
a) When the digital extender function is turned on, it is
not possible to show the return video.
a) When the digital extender function is turned on, it is
not possible to show the return video.
Electrical CC Function that switches the electrical CC filter (3200K/
4300K/5600K/6300K) applied to white balance
adjustment values.
Each press of the switch or button switches in the order
3200Kt4300Kt5600Kt6300K.
These can also be applied from a menu (apply with
Electric
al CC<A><B><C
><D>).
Note
This function is not available when White Filter >ND
Filter C.Temp in the Maintenance menu is set to On.
If you set ND Filter C.Temp to On after assigning the
function, the assignable switch ceases to function.
Setting retained
CC5600K Apply a 5600K electrical CC filter to white balance
adjustment values.
Setting retained
Digital Extender
a)
Turn the screen magnification function on or off Turn the
screen magnification function on or off when the optional
CBK-CE01 50 Pin Interface and Digital Extender is
installed.
Setting not retained
Assignable switch setting Function State when camcorder
is next powered on
Functions That Can Be Assigned to the RET Button on the Lens
Assignable switch setting Function State when camcorder
is next powered on
Off No assignment —
Lens RET Display return video signals when the optional CBK-
CE01 is installed and a camera extension unit is
connected.
When a camera extension unit is not connected, function
as follows.
During recording or playback: Write a shot mark.
In the other states: Conduct a recording review (if
playback is allowed).
—
Return Video
a)
Display return video signals when the optional CBK-
CE01 is installed and a camera extension unit is
connected.
—
Rec Review Execute recording review. —
Shot Mark1 Write Shot Mark1. —
Shot Mark2 Write Shot Mark2. —
OK Mark Add or delete an OK mark. —
Focus Mag Turn the focus magnification function on or off. Setting not retained
To Next Page
Loading...
