Showing or hiding meters
You can display a peak meter, VU/PPM, a phase scope, and mono-compatibility meter for each hardware output. To toggle the display of
each meter, right-click the Hardware Meters window and choose a command from the shortcut menu.
A check mark is displayed to indicate which meters are currently visible.
For more information about peak meters, see Using the channel meters on page 44.
For more information about VU/PPM meters, see Using the VU/PPM meters on page 46.
For more information about phase scopes, see Using phase scopes on page 48.
For more information about mono-compatibility meters, see Using the mono-compatibility meters on page 48.
112
| CHAPTER 6
To Next Page
Loading...
