Adjustment Using the Menus
28
[Camera Metadata Setting]
[WFM/ALM/Vector (waveform monitor,
audio level meter, and vectorscope) Setting]
[Focus Mode] Switches the camera focus mode.
[Color]: Displays the intensified areas
of images with color selected in
the color setting below.
[Color]: Selects the displayed
intensified color from among
[Red], [Green], [Blue],
[Yellow], [White].
[Standard]: An image with
sharpened edges is displayed.
[Frequency] Sets the center frequency of the edge
sharpening signal. You can select from
among [Low], [Middle], [Middle High],
[High].
[Range] Sets the target of edge sharpening. You
can select from among [Narrow],
[Middle], [Wide].
[Gain] Sets the level of edge sharpening.
Submenu Setting
[Metadata] Sets the display of the camera metadata.
Select [On] to display the camera
metadata and [Off] to not display.
Submenu Setting
[Metadata1] to
[Metadata12]
Assigns the camera metadata to be
displayed on the screen. You can assign
from the following:
[Iris F-Number]
[Iris T-Number]
[Focus Position]
[Focus Ring Position]
[Macro Setting]
[Lens Zoom (35mm)]
[Lens Zoom (focal)]
[Zoom Ring Position]
[Optical Extender Mag]
[Lens Attribute]
[Neutral Density Filter]
[Capture Frame Rate]
[Shutter Speed (Angle)]
[Shutter Speed (Time)]
[Camera Master Gain]
[ISO Sensitivity]
[Electrical Extender Mag]
[AWB Mode]
[White Balance]
[Capture Gamma]
[Monitoring Base Curve]
[Monitoring Descript]
[Focus Distance(Cooke)]
[Hyperfocal D. (Cooke)]
[Displayed Rows] Sets the display row number.
[1row]: Displays four items of the
metadata in a row.
[2rows]: Displays eight items of the
metadata in two rows.
[3rows]: Displays 12 items of the
metadata in three rows.
[Position] Sets the display position of the
metadata. Select [Top] or [Bottom].
[Units] Sets the unit of distance. Select [Feet] or
[Meter].
Submenu Setting
[Display] Select [On] to display the [WFM]
(waveform monitor), [ALM] (audio
level meter), or [Vector] (Vectorscope);
or [Off] not to display.
Submenu Setting
To Next Page
Loading...
