There is no sound from the component
connected to
the
DIGITAL MEDIA PORT
adapter.
• Adjust the volume
of
this receiver.
• The DIGITAL MEDIA PORT adapter
and/or component
is
not connected
correctly. Turn
off
the receiver, then
reconnect the DIGITAL MEDIA PORT
adapter and/or component.
• Check the DIGITAL MEDIA PORT
adapter and/or component device
to
make
sure it supports this receiver.
There is no picture or an unclear
picture appears on the TV screen.
• Select the appropriate input using the input
buttons.
• Set your TV to the appropriate input mode.
• Move your audio components away from
the
TV.
• Depending
on
the DIGITAL MEDIA
PORT adapter, video output may not be
possible.
Recording cannot be carried out.
• Check that the components are connected
correctly (page 15).
• Select the source component using the
input buttons (page 22).
54
US
TUler
The FM reception is poor.
• Use a 75-ohm coaxial cable (not supplied)
to connect the receiver to an outdoor FM
antenna (aerial) as shown below.
If
you
connect the receiver to an outdoor antenna
(aerial), ground it against lightning.
To
prevent a gas explosion, do not connect the
ground (earth) wire to a gas pipe.
Outdoor
FM
antenna (aerial)
Receiver
F"
750
COAXIAL
Ground
(earth)
wire
(not
supplied)
.~t:
@ +
To
ground
Radio stations cannot be tuned in.
• Check that the antennas (aerials) are
connected securely. Adjust the antennas
(aerials) and connect an external antenna
(aerial),
if
necessary.
• Keep the satellite radio antenna away from
the speaker cords and the power cord
(mains lead) to avoid picking up noise.
• The signal strength
of
the stations
is
too
weak (when tuning in with automatic
tuning). Use direct tuning.
• Make sure you set the tuning interval
correctly (when tuning in AM stations
with direct tuning).
• No stations have been preset
or
the preset
stations have been cleared (when tuning
by
scanning preset stations). Preset the
stations (page 31).
• Press DISPLAY repeatedly on the receiver
so that the frequency appears on the
display.
To Next Page
