89
GB
Using Other Features
Reverting back to the
factory default settings
You can clear all memorized settings and
revert the receiver back to the factory default
settings by performing the following
procedure. This procedure can also be used to
initialize the receiver before you use it for the
first time.
1 Press ?/1 to turn off the
receiver.
2 While holding down the TONE
and 2CH/A.DIRECT, press ?/1
to turn on the receiver.
3 Release the TONE and 2CH/
A.DIRECT after a few seconds.
The “MEMORY CLEARING...” appears
on the display window for a while, then
changes to “MEMORY CLEARED!”
Changes or adjustments made to the
settings are now reset to the defaults.
Note
It takes about a few minutes for the memory to be
cleared completely. Do not turn the receiver off until
“MEMORY CLEARED!” appears on the display.
?/1
TONE 2CH/A.DIRECT
To Next Page
Loading...
