[145] Adjusting Settings Speaker Settings
Checking the speaker position and the corresponding
speaker terminals (Speaker Connection Guide)
This function lets you know the position of the speaker you select and the corresponding
speaker terminals on the receiver to which the speaker should be connected.
[146] Adjusting Settings Speaker Settings
Assigning the surround speaker terminals (Surround
Speaker Assign)
You can set the assignment for the SPEAKERS SURROUND/ZONE 3 terminals.
Note
You can only set [Surround Speaker Assign] under the following conditions:
The speaker pattern is set to a setting without surround speakers.
Headphones are not connected.
[Bluetooth Mode] is set to other than [Transmitter].
[147] Adjusting Settings Speaker Settings
Assigning the surround back speaker terminals
(Surround Back Speaker Assign)
You can set the assignment for the SPEAKERS SURROUND BACK/BI-AMP/FRONT
HIGH/FRONT B terminals.
Select [Setup] - [Speaker Settings] from the home menu.
1
Select [Speaker Connection Guide].
2
Select the speaker you want from the list on the right side of the screen.
The position of the speaker and the corresponding terminals on the receiver to which the
speaker should be connected are shown on the screen.
3
Select [Setup] - [Speaker Settings] from the home menu.
1
Select [Surround Speaker Assign].
2
Select the setting you want.
Off
Zone3: When using the Zone 3 connection.
3
Select [Setup] - [Speaker Settings] from the home menu.
1
Select [Surround Back Speaker Assign].
2
To Next Page
Loading...
