Note
You can only set [Surround Back Speaker Assign] under the following conditions:
The speaker pattern is set to a setting without surround back and front high speakers.
Headphones are not connected.
[Bluetooth Mode] is set to other than [Transmitter].
[148] Adjusting Settings Speaker Settings
Setting the priority on the surround back speakers or
Zone 2 speakers (SURROUND BACK/ZONE2 Priority)
When speakers are connected to both the SPEAKERS SURROUND BACK/BI-AMP/FRONT
HIGH/FRONT B terminals and SPEAKERS ZONE 2 terminals, you can set which speakers are
given priority.
Note
When [Zone2 Power] is set to [Off], the SPEAKERS SURROUND BACK/BI-AMP/FRONT
HIGH/FRONT B terminals are enabled even if [ZONE2 Terminals] is selected.
When [ZONE2 Terminals] is selected and [Zone2 Power] is set to [On], [Zone2 Power] will be set to
[Off] automatically if the [Speaker Pattern] is set to [5.0] or higher.
[149] Adjusting Settings Speaker Settings
Adjusting the speaker size (Size)
You can adjust the size of each speaker (front left/right, front high left/right, center, surround
left/right, surround back left/right).
Select the desired speaker pattern according to the speaker installation example
displayed on the TV screen, then select [Save].
3
Select the setting you want (*).
Off: When none of the connections above is used.
Front B: When using the front B speaker connection.
Bi-Amp: When using the bi-amplifier speaker connection.
4
The displayed settings vary depending on the speaker pattern you selected.
*
Select [Setup] - [Speaker Settings] from the home menu.
1
Select [SURROUND BACK/ZONE2 Priority].
2
Select the setting you want.
ZONE2 Terminals: Priority is placed on the SPEAKERS ZONE 2 terminals.
SURROUND BACK Terminals: Priority is placed on the SURROUND BACK/BI-
AMP/FRONT HIGH/FRONT B terminals and the SPEAKERS ZONE 2 terminals are
disabled.
3
To Next Page
Loading...
