You can check a list of products compatible with a controller on the home network and set
whether or not each product is accessible via this receiver.
[195] Adjusting Settings Network Settings
Checking the registered Video & TV SideView device
(Registered Remote Devices)
You can check the Video & TV SideView devices which are able to control the receiver.
Note
You can register up to 5 Video & TV SideView devices. If you want to add a new device when a
maximum of 5 devices are set, remove unnecessary devices before adding the new device.
[196] Adjusting Settings Network Settings
Enabling the network function even when this receiver
is in standby mode (Remote Start)
If this function is set to [On], the receiver can be turned on by a device via the network when the
receiver is in standby mode.
[197] Adjusting Settings Network Settings
Select [Setup] - [Network Settings] from the home menu.
1
Select [Home Network Access Control].
A list of registered controllers appears (up to 40 devices).
2
Select the controller you want to set and press
.
3
Select the setting you want.
Allow: Permits access from the controller.
Block: Blocks access from the controller.
4
Select [Setup] - [Network Settings] from the home menu.
1
Select [Registered Remote Devices].
2
Select [Setup] - [Network Settings] from the home menu.
1
Select [Remote Start].
2
Select [On] or [Off].
3
To Next Page
Loading...
