2. Select [Renderer Access Control].
A list of registered controllers appears (up to 40 devices).
3. Select the controller you want to set and press .
4. Select the setting you want.
Allow: Permits access from the controller.
Block: Blocks access from the controller.
[92] Using Network Features Setting whether to control this receiver from a device on the
home network
Enabling automatic access from a newly detected
controller device (Auto Renderer Access Permission)
You can set whether or not the receiver allows automatic access from a newly detected
controller device on the home network.
1. Select [Setup] - [Network Settings] from the home menu.
2. Select [Auto Renderer Access Permission].
3. Select the setting you want.
On
Off
[93] Using Network Features Setting whether to control this receiver from a device on the
home network
Deleting devices from the device list in Renderer Access
Control
1. Select [Setup] - [Network Settings] from the home menu.
2. Select [Renderer Access Control].
To Next Page
Loading...
