4. Set [Sur Back SP Assign] to any of the following settings (*).
Zone2 (for STR-DN1060 only)
When using the Zone 2 connection.
Bi-Amp
When using the bi-amplifier connection.
Front B
When using the front B speaker connection.
Off
When none of the connections above are used.
*
The displayed settings vary depending on the speaker pattern you selected in step 3.
Note
You can only set [Sur Back SP Assign] under the following conditions:
The speaker pattern is set to a setting without surround back and front high speakers.
Headphones are not connected.
[Bluetooth Mode] is set to other than [Transmitter].
[145] Adjusting Settings Speaker Settings
Adjusting the speaker size (Size)
You can adjust the size of each speaker (front left/right, front high left/right, center, surround
left/right, surround back left/right).
1. Select [Setup] - [Speaker Settings] from the home menu.
2. Select [Size].
3. Select the speaker on the screen for which you want to adjust the size.
4. Select the size you want.
Large: If you connect large speakers that will effectively reproduce bass
frequencies, select [Large]. Select [Large] usually.
Small: If the sound is distorted, or you hear a lack of surround effects when using
multi channel surround sound, select [Small]. You can activate the bass redirection
circuitry and output the bass frequencies of each channel from the subwoofer or
other [Large] speakers.
To Next Page
Loading...
