Sony STR-DN860 - Page 146

only)
You can select the speaker pattern for the SPEAKERS SURROUND terminals and set how
to assign the terminals.
1. Select [Setup] - [Speaker Settings] from the home menu.
2. Select [Speaker Pattern].
3. Select the desired speaker pattern according to the speaker installation example
displayed on the TV screen, then select [Save].
4. Set [Surround SP Assign] to any of the following settings (*).
Zone3: When using the Zone 3 connection.
Off
*
The displayed settings vary depending on the speaker pattern you selected in step 3.
Note
You can only set [Surround SP Assign] under the following conditions:
The speaker pattern is set to a setting without surround speakers.
Headphones are not connected.
[Bluetooth Mode] is set to other than [Transmitter].
[144] Adjusting Settings Speaker Settings
Selecting the speaker pattern and setting the assignment
for the speaker terminals (Speaker Pattern/Sur Back SP
Assign)
You can select the speaker pattern and set the assignment for the SPEAKERS SURROUND
BACK/BI-AMP/FRONT HIGH/FRONT B terminals.
1. Select [Setup] - [Speaker Settings] from the home menu.
2. Select [Speaker Pattern].
3. Select the desired speaker pattern according to the speaker installation example
displayed on the TV screen, then select [Save].