Sony VPL-EW348 - Connection and Power Menu Settings

31
The Connection/Power Menu
Adjustments and Settings Using a Menu
The Connection/Power Menu
The Connection/Power menu is used for setting for the connections and power.
Items Item descriptions
LAN Settings
IP Address
Setup
*9
Auto (DHCP): The IP address is assigned automatically from the
DHCP server such as a router.
Manual: To specify the IP Address manually.
WLAN Settings
*10
WLAN
Connection
*8
On/Off: Set the wireless output of the USB wireless LAN module (not
supplied) to On/Off.
WLAN
Network
*14
Access Pt./Client
*11
: Changes modes for WLAN.
*12
Network Presentation
Connection
CODE
On/Off: This is the presentation function via the network. It controls
the connection using the displayed number (CODE) on the right bottom
of the screen. During the image transmission, using the ENTER key on
the remote commander makes Connection CODE display again.
Display Setting
LAN Mode Displays the LAN settings of the projector or the
settings of the USB wireless LAN module that operates
as a client at the bottom right of the screen.
Wired: Displays the IP address of LAN preferentially.
Wireless: Displays the IP address of the USB wireless
LAN module preferentially.
AP Mode Displays the SSID of the USB wireless LAN module
that operates as an access point at the bottom right of the
screen.
HDBaseT setting Sets the function of the HDBaseT/LAN terminal. (VPL-EW348 only)
HDBaseT/LAN
terminal
HDBaseT: Connecting the HDBaseT transmitter and the LAN cable
enables transmitting the signal of the Video, Audio, Ethernet, and
RS-232C.
LAN: Connecting the LAN cable for Ethernet directly enables
connecting to the network.
(Use when connecting the cable directly without the HDBaseT
transmitter.)
RS-232C setting Via HDBaseT: You can connect this unit to the RS-232C terminal via
the HDBaseT transmitter. (Baud rate: 9600bps)
RS-232C terminal: Use when connecting to the RS-232C terminal of
this unit directly.
Dynamic Range
*15
Sets the image input level of the INPUT C/D/E terminal.
*16
Auto: Distinguishes the image input level automatically.
Limited: Set when the image input level is 16-235.
Full: Set when the image input level is 0-255.