Sorensen DCS40-75 - SECTION 1 INTRODUCING THE DCS SERIES SYSTEM SUPPLY

Contents Sorensen DCS Series 3kW Supplies
2.5 AC Input Power Connection.............................................................................2-4
2.5.1 AC Input Power Requirements.............................................................2-4
2.5.2 AC Input Connector Assembly .............................................................2-5
2.5.3 Strain Relief Assembly .........................................................................2-6
2.6 Initial Functional Tests .....................................................................................2-8
2.6.1 Power-on Check...................................................................................2-8
2.6.2 Voltage Mode Operation Check ...........................................................2-8
2.6.3 Current Mode Operation Check ...........................................................2-9
2.6.4 Front Panel Function Checks...............................................................2-9
2.7 Load Connection............................................................................................2-10
2.7.1 Load Wiring ........................................................................................2-10
2.7.2 Making the Connections.....................................................................2-11
2.7.3 Connecting Single Loads ...................................................................2-12
2.7.4 Connecting Multiple Loads.................................................................2-12
SECTION 3 BASIC OPERATION ........................................................ 3-1
3.1 Introduction ......................................................................................................3-1
3.2 Standard Operation..........................................................................................3-1
3.2.1 Operating Modes and Automatic Crossover ........................................3-1
3.2.2 Local Programming Mode Operation ...................................................3-3
3.3 Using Remote Sensing ....................................................................................3-4
3.3.1 Connecting Remote Sense Lines.........................................................3-4
SECTION 4 ADVANCED OPERATION................................................ 4-1
4.1 Introduction ......................................................................................................4-1
4.2 Configuring for Remote Programming, Sensing, and Monitoring....................4-2
4.2.1 Programming, Monitoring, and Control Functions................................4-2
4.2.2 Locating Jumpers, Switch, and Connector...........................................4-4
4.2.3 Resetting Jumpers and Switch.............................................................4-5
4.2.4 Making J3 Connections........................................................................4-6
iv Operation Manual