Sourcetronic ST600 Series - Page 115

Frequency Inverter ST600 Series High-Performance Multifunction VFD Basic Operation Instructions
-108-
Related parameter list:
Function
code
Name
Description
Default
value
P06.00
HDO output type
0: Open collector high-speed pulse output
1: Open collector output
0
P06.01
Y1 output selection
0: Invalid
1: In running
2: In forward running
3: In reverse running
4: In jogging
5: VFD fault
6: Frequency level detection FDT1
7: Frequency level detection FDT2
8: Frequency reached
9: Running in zero speed
10: Reach upper limit frequency
11: Reach lower limit frequency
12: Ready to run
13: In pre-exciting
14: Overload pre-alarm
15: Underload pre-alarm
16: Simple PLC stage completed
17: Simple PLC cycle completed
18: Reach set counting value
19: Reach designated counting value
20: External fault is valid
21: Reserved
22: Reach running time
23: Virtual terminal output of Modbus/Modbus
TCP communication
24: Virtual terminal output of
POROFIBUS/CANopen communication
25: Virtual terminal output of Ethernet
communication
26: DC bus voltage established
27: Z pulse output
28: During pulse superposition
29: STO action
30: Positioning completed
31: Spindle zeroing completed
32: Spindle scale-division completed
33: Speed limit reached in torque control
34: Virtual terminal output of
EtherCAT/PROFITNET/Ethernet IP
communication
35: Reserved
36: Speed/position control switch-over completed
0
P06.02
HDO output selection
0
P06.03
Relay RO1 output selection
1
P06.04
Relay RO2 output selection
5