Sourcetronic ST600 Series - Single-unit installation

Frequency Inverter ST600 Series High-Performance Multifunction VFD Installation Guide
-20-
Installation:
(1) Mark the position of the installation hole. See Appendix C "Dimension drawings" for the position of
the installation hole;
(2) Mount the screws or bolts onto the designated position;
(3) Put the VFD on the wall;
(4) Tighten the fixing screws on the wall.
4.2.4 Single-unit installation
Figure 4-5 Single-unit installation (standard models)
Cold air
Hot air
C
C
A
B
A
B
Figure 4-6 Single unit installation (SP models)
A
B B
A
Cold air
Hot air
C
C
Note: The min. dimension of A, B, and C is 100mm.