Sourcetronic ST600 Series - Monitoring states; Autotuning motor parameters

Frequency Inverter ST600 Series High-Performance Multifunction VFD Basic Operation Instructions
-53-
Figure 5-17 Editing parameters in parameter groups
In parameter selection edit interface, the "Authority" in the top right indicates whether this parameter
can be modified or not.
"√" indicates the set value of this parameter can be modified under current state.
"×" indicates the set value of this parameter cannot be modified under current state.
"Present" indicates the present value.
"Default" indicates the default value of this parameter.
5.4.7 Monitoring states
You can choose Menu > State monitoring > State monitoring parameter, enter a specific function
group and then a specific function code, and press key, key or key to enter the
state monitoring interface. After entering the state monitoring interface, the actual parameter value will
be displayed in real time; this value is the actually detected value which cannot be modified.
In the state monitoring interface, you can press key or key to return to the previous menu.
Figure 5-18 State monitoring interface
5.4.8 Autotuning motor parameters
You can choose Menu > Motor parameter autotune and press key, key or key to
enter motor parameter autotuning interface. However, before entering the motor parameter autotuning
interface, you must set the motor nameplate parameters correctly. After entering the interface, select
a motor autotuning type to carry out motor parameter autotuning. In motor parameter autotuning
interface, you can press key or key to return to the previous menu.
01: ST600
16:02:35
Forward
Local Ready
P00.00: Speed control mode
P00.01: Running command channel
P00.02: Communication command channel
P00.03: Max. output frequency
P00.04: Upper limit of running frequency
P00.05: Lower limit of running frequency
Max. output frequency Hz
050.00
Max. value: 630.00
Min. value: 50.00
Current value: 50.00
Authority: √
Default value: 50.00
Max. output frequency Hz
050.01
Max. value: 630.00
Min. value: 50.00
Current value: 50.00
Authority: √
Default value: 50.00
AddReturn
Select
Hom epageReturn
Confirm
Hom epageReturn
Confirm
HomepageReturn
Confirm
Setting frequency Hz
50.00
Max. value: 630.00
Min. value: 0.0
01: ST600
16:02:35
Forward
Local Ready
01: ST600
16:02:35
Forward
Local Ready
AddReturn
Select
P17.00: Set frequency
P17.01: Output frequency
P17.02: Ramps reference frequency
P17.03: Output voltage
P17.04: Output current
P17.05: Motor speed
Default value: 0.0