Sourcetronic ST600 Series - Editing user defined parameters; Editing parameters in parameter groups

Frequency Inverter ST600 Series High-Performance Multifunction VFD Basic Operation Instructions
-52-
parameter setup list menu.
All the function code groups under the parameter group menu can be added to the user defined
parameter list. Up to 64 function codes can be added to the user defined parameter list.
5.4.5 Editing user defined parameters
After accessing a specific function code under the User defined parameters menu, you can press
key, key or key to enter parameter selection edit interface. After entering the edit
interface, the present value will be highlighted. Press key and key to edit the present
parameter value, and the corresponding parameter item of the value will be highlighted automatically.
After parameter selection is done, press key or key to save the selected parameter and
return to the previous menu. In parameter selection edit interface, press key to maintain the
parameter value and return to the previous menu.
Figure 5-16 Editing user defined parameters
In parameter selection edit interface, the "Authority" in the top right indicates whether this parameter
is editable or not.
"√" indicates the set value of this parameter can be modified under current state.
"×" indicates the set value of this parameter cannot be modified under current state.
"Present" indicates the present value.
"Default" indicates the default value of this parameter.
5.4.6 Editing parameters in parameter groups
You can choose Menu > Parameter groups, enter a specific function group and then a specific function
code, and then press key, key or key to enter the parameter setting interface. After
entering the edit interface, set the parameter from the low bit to high bit, and the bit under setting will
be highlighted. Press key or key to increase or decrease the parameter value (this
operation is valid until the parameter value exceeds the max. value or min. value); press or
to shift the edit bit. After the parameter is set, press key or key to save the setting and
return to the previous menu; press to maintain the original parameter value and return to the
previous menu.
Current value: 0
Authority: √
Hom epageReturn
Confirm
0: SVC 0
1: SVC 1
2: V/F mode
3: VC mode
Current value: 1
Authority: √
Hom epageReturn
Confirm
1: SVC 1
2: V/F mode
3: VC mode
Default value: 2
Default value: 2
01: ST600
16:02:35
Forward
Local Ready
AddReturn
Select
P00.00: S peed control m ode
P00.01: Running command channel
P00.02: C ommunication command channel
P00.03: M ax. output frequency
P00.04: U pper limit of running frequency
P00.05: Lower limit of running frequency