Sourcetronic ST600 Series - Local Encoder Input

Frequency Inverter ST600 Series High-Performance Multifunction VFD Basic Operation Instructions
-120-
7: Set via PID control
8: Set via Modbus/Modbus TCP
communication
9: Set via PROFIBUS/CANopen/ DeviceNet
communication
10: Set via Ethernet communication
11: Set via high-speed pulse HDIB
12: Set via pulse train AB
13: Set via EtherCAT/PROFITNET/Ethernet
IP communication
14: Set via PLC card
P00.11
Acceleration time 1
0.0–3600.0s
Model-
dependent
P00.12
Deceleration time 1
0.0–3600.0s
Model-
dependent
P05.01–
P05.06
Digital input function selection
26: Wobbling frequency pause (stop at
current frequency)
27: Wobbling frequency reset (revert to center
frequency)
/
P08.15
Amplitude of wobbling
frequency
0.0–100.0% (relative to set frequency)
0.0%
P08.16
Amplitude of jump frequency
0.0–50.0% (relative to amplitude of wobbling
frequency)
0.0%
P08.17
Wobbling frequency rise time
0.1–3600.0s
5.0s
P08.18
Wobbling frequency fall time
0.1–3600.0s
5.0s
5.5.17 Local encoder input
The ST600 Series VFD supports pulse count function by inputting the count pulse from HDI high-
speed pulse port. When the actual count value is no less than the set value, digital output terminal will
output count-value-reached pulse signal, and the corresponding count value will be zeroed out.
Function
code
Name
Description
Default
value
P05.00
HDI input type
0x00–0x11
Ones: HDIA input type
0: HDIA is high-speed pulse input
1: HDIA is digital input
Tens: HDIB input type
0: HDIB is high-speed pulse input
1: HDIB is digital input
0x00
P05.38
HDIA high-speed pulse input
function
0: Set input via frequency
1: Reserved
2: Input via encoder, used in combination with
HDIB
0