Frequency Inverter ST600 Series High-Performance Multifunction VFD Function parameter list
-187-
Select corresponding acceleration/deceleration time, and
then convert 16-bit binary number into hexadecimal
number, finally, set corresponding function code.
Acceleration/deceleration time 1 is set by P00.11 and
P00.12; Acceleration/deceleration time 2 is set by P08.00
and P08.01; Acceleration/deceleration time 3 is set by
P08.02 and P08.03; Acceleration /deceleration time 4 is
set by P08.04 and P08.05.
Setting range: 0x0000–0xFFFF
0: Restart from the first step, namely if the VFD stops
during running (caused by stop command, fault or power
down), it will run from the first step after restart.
1: Continue running from the step frequency when
interruption occurred, namely if the VFD stops during
running (caused by stop command or fault), it will record
the running time of current step, and enters this step
automatically after restart, then continue running at the
frequency defined by this step in the remaining time.
0: s; the running time of each step is counted in seconds;
1: min; the running time of each step is counted in
minutes.
To Next Page
Loading...
