Sourcetronic ST600 Series - Keypad display

Frequency Inverter ST600 Series High-Performance Multifunction VFD Basic Operation Instructions
-42-
(8)
Confirmation
key
The function of confirmation key varies with menus,
e.g. confirming parameter setup, confirming
parameter selection, entering the next menu, etc.
(9)
Running key
Under keypad operation mode, the running key is
used for running operation or autotuning
operation.
(10)
Stop/
Reset key
During running state, press the Stop/Reset key
can stop running or autotuning; this key is limited
by P07.04. During fault alarm state, all the control
modes can be reset by this key.
(11)
Direction key
UP:
DOWN:
LEFT:
RIGHT:
UP: The function of UP key varies with interfaces,
e.g. shifting up the displayed item, shifting up the
selected item, changing digits, etc;
DOWN: The function of DOWN key varies with
interfaces, e.g. shifting down the displayed item,
shifting down the selected item, changing digits, etc;
LEFT: The function of LEFT key varies with
interfaces, e.g. switch over the monitoring interface,
e.g. shifting the cursor leftward, exiting current menu
and returning to previous menu, etc;
RIGHT: The function of RIGHT key varies with
interfaces, e.g. switch over the monitoring
interface, shifting the cursor rightward, enter the
next menu etc.
3
Display
area
(12)
LCD
Display
screen
240×160 dot-matrix LCD; display three monitoring
parameters or six sub-menu items simultaneously
4
Others
(13)
RJ45
interface
RJ45
interface
RJ45 interface is used to connect to the VFD.
(14)
Battery
holder
Clock battery
holder
The battery holder is used for replacing or
installing a battery for the clock.
(15)
USB
terminal
mini USB
terminal
Mini USB terminal is used to connect to the USB
flash drive through an adapter.
The LCD has different display areas, which displays different contents under different interfaces. The
figure below is the main interface of stop state.