Sourcetronic ST600 Series - Page 97

Frequency Inverter ST600 Series High-Performance Multifunction VFD Basic Operation Instructions
-90-
P00.08
Reference object of B
frequency command
0: Max. output frequency
1: A frequency command
0
P00.09
Combination mode of setup
source
0: A
1: B
2: (A+B)
3: (A-B)
4: Max (A, B)
5: Min (A, B)
0
P05.01–
P05.06
Function of multi-function
digital input terminal (S1–S4,
HDIA, HDIB)
10: Frequency increase (UP)
11: Frequency decrease (DOWN)
12: Clear frequency increase/decrease setting
13: Switch-over between setup A and setup B
14: Switch-over between combination setup
and setup A
15: Switch-over between combination setup
and setup B
/
P08.42
Reserved
/
/
P08.43
Reserved
/
/
P08.44
UP/DOWN terminal control
0x000–0x221
Ones: Frequency enabling selection
0: UP/DOWN terminal setting is valid
1: UP/DOWN terminal setting is invalid
Tens: Frequency control selection
0: Valid only when P00.06=0 or P00.07=0
1: Valid for all frequency modes
2: Invalid for multi-step speed when multi-step
speed takes priority
Hundreds: Action selection at stop
0: Valid
1: Valid during running, clear after stop
2: Valid during running, clear after receiving
stop command
0x000
P08.45
UP terminal frequency
incremental change rate
0.01–50.00 Hz/s
0.50 Hz/s
P08.46
DOWN terminal frequency
decremental change rate
0.01–50.00 Hz/s
0.50 Hz/s
P17.00
Set frequency
0.00Hz–P00.03 (max. output frequency)
0.00Hz
P17.02
Ramps reference frequency
0.00Hz–P00.03 (max. output frequency)
0.00Hz
P17.14
Digital adjustment value
0.00Hz–P00.03
0.00Hz