35SC-CF-SBD Owner’s Manual
Instructions
Main Spa Side Control • Single Pump System
Filter Cycles
• Press Light key and hold for
5 seconds.
• The display will show a digit that
represents the duration of the
filter cycle in hours.
• Use Up & Down arrow keys
to change setting.
0 = no filtration
12 = continuous filtration
• When the desired setting is
displayed, press Light key
again. The filter cycle will start.
The "Filter" indicator lights up
when a filter cycle is on.
Note that after a power failure, the filter cycle duration will return to its default
value (6 hours, twice a day). In this case, the first filter cycle will start 12 hours
after power has been restored.
The system will automati-
cally perform two filtering
cycles per day, 12 hours
apart. During a cycle, the
pump will start in high
speed for 1 minute then
will run in low speed for a
predetermined number of hours.
The ozonator is always on during a filter cycle.
To set the duration of the filtering cycle (the amount
of time the pump will be on), follow this procedure:
To Next Page
Loading...
