Page 33 of 34
when plugged in.
• Physical damage to the antenna ports will render your device unusable and is
not covered by the manufacturer’s warranty.
• The internal battery is not replaceable by the end user. Return to your service
centre for repair.
• Do not disassemble the case to change the battery, do not disassemble or short
circuit the battery terminals.
• Do not dispose of the unit in a fire, the internal battery may explode.
• At the end of life of the equipment, return the product to a suitable recycling
agent such as Mobile Muster.
RF SAFETY INFORMATION
The Wi-Fi modem has internal antennas. For optimum performance with minimum
power consumption do not shield the device or cover with any object.
Covering the antennas affects signal quality and may cause the modem to operate
at a higher power level than needed.
RADIO FREQUENCY ENERGY
The Wi-Fi modem is a low-power radio transmitter and receiver. When switched
on it intermittently transmits radio frequency (RF) energy (radio waves).
The transmit power level is optimized for best performance and automatically
reduces when there is good quality reception.
Maximum power is only used at the edge of network coverage so under most
circumstances the power output is very low.
Under poor network conditions the modem transmits at a higher power level and
may get hot.
DECLARATION OF CONFORMITY – SPECIFIC ABSORPTION RATE (SAR)
The Wi-Fi modem is designed to be used in close proximity to the body. We
declare that the product detailed in this manual, and in combination with our
accessories, conform with the essential requirements of Section 134 (1) (g) of the
New Zealand Radiocommunications Act 1989 when used at a distance of not less
than 10mm from the body. The worst case SAR result is 1.458W/Kg (10g average)
with 10mm spacing in the Body position. The limit is 2.0W/Kg
Z1196
To Next Page
Loading...