Need help?Do you have a question about the SPE EXPERT 1.5K-FA and is the answer not in the manual?
Explains the manual's four main parts and their content for understanding.
Lists critical warnings regarding electrical shock, modification, handling, and environment.
Covers safe handling, operating temperatures, dust, moisture, and children's safety.
Details on how to unpack the amplifier and lists all included accessories.
Identifies and explains all buttons, LEDs, and the display on the front panel.
Details the connectors and switches located on the rear panel of the amplifier.
Describes the power supply features and the dual input/output capabilities.
Explains the functions of ALC, Relay, and CAT connections for transceiver control.
Provides guidance on connecting the amplifier to a transceiver.
Outlines the OFF, STANDBY, and OPERATE modes of the linear amplifier.
Details the setup and operation for Single Operator Two Radio (SO2R).
Explains the optional SPE BPF1 unit for increased band isolation.
Covers QSK (Full Break-In) operation and control of tunable antennas.
Describes setting up single receiving antennas and two antenna memory banks.
Explains using the SMA connector for signal predistortion improvements.
Provides essential guidelines for establishing a proper RF ground connection.
Discusses antenna requirements, ratings, and SWR measurements.
Explains the switching power supply, its features, and standards compliance.
Details the operation, matching capabilities, and bypassing of the internal ATU.
Describes the system's protection mechanisms and different alarm types.
Guides on how to program settings like CONFIG, ANTENNA, CAT, and MANUAL TUNE.
Steps for initial programming, including CONFIG, ANTENNAS, and CAT setup.
Covers general operating practices and monitoring the amplifier during transmission.
Details how to set appropriate driving levels for various transmission modes.
Details the CAT connector pinout and various transceiver interface types.
Explains BAND DATA interface and connections for specific transceiver brands.
Covers ALC, Relay, Remote ON, TX-INH links, AUX, and PORT connectors.
Guides on controlling the transceiver via PC using CAT utility.
Explains remote control and firmware download via USB/RS232 ports.
Details on installing and using the Term_1.5K_USB/232 software.
How to enable selective addressing for multiple amplifiers on a USB hub.
Instructions for cleaning the air filter and fans to maintain the amplifier.
How to perform a factory reset of the amplifier's settings.
Comprehensive list of technical features, performance, and physical specifications.
Outlines the warranty period, coverage, and purchaser obligations.
Details on how to fill out the repair form for service requests.
General| Cooling | Forced Air |
|---|---|
| Power Output | 1500W PEP or continuous carrier |
| Modes | SSB, CW, RTTY, FM, AM |
| Supply voltage | 50Hz - 60Hz |
| Input Impedance | 50 ohms |
To Next Page
