INDEX Page. 56 of 89
- Very clean and low distortion output:
Spurious emissions FCC/CE compliant.
3rd order distortion (two tone test) from -30 dB to -35 dB ( typ. ).
- Input 50 ohm always perfectly matched:
The same protection is realized in two different ways:
Via hardware circuits (HW) to assure great speed.
Via software (SW), to assure great accuracy.
Thanks to the sophisticated software, the transmit relay changeover is carried
out with zero current on the contacts.
- Full break-in operation (QSK).
- Quiet operation:
Linear management of the speed of the cooling fans of the heatsink.
The amplifier develops a significant amount of heat that must be removed.
Therefore, every precaution is used to keep the fan noise at the lowest possible
level. Fan noise is significantly lower than with tube type amplifiers.
- Use:
Unlimited in SSB and CW.
In FM automatically switches to "MID" if for 8 minutes. a continuous signal
is emitted in "MAX" (room temperature 20 ° C / 68 ° F).
Full I.C.A.S. for all digital modes currently in use.
- Switching power supply:
Continuously operable at inputs between 100 – 255 VAC, 47-63 Hz.
(100-120 VAC may cause slightly reduced output power).
PFC (Power Factor Correction).
- The linear can be switched ON / OFF by switching the exciter ON / OFF.
- Full remotely useable.
- With a large LCD display, it is possible to have a great deal of information:
Watts pep out, Vpa, Ipa, Watts, Temperatures, SWR (after and before the ATU),
Input setting, CAT setting, Band and other indications including the alarms log.
- Easy to operate:
Powerful and sophisticated software gives you a user-friendly unit.
- USB / RS232 ports:
For remote control.
For new software releases download.
- Easy transportation:
A sturdy carry-bag is supplied for QSY, FIELD DAY, DXpeditions etc.
- Certifications:
CE, FCC. N.B. These specifications are subject to change without notice.
To Next Page
Loading...
