To Next PageTo Next Page
Need help?Do you have a question about the Spectra Precision Trimble GL622 and is the answer not in the manual?
General| Range | Up to 800 m (2, 600 ft) diameter |
|---|---|
| Rotation Speed | 300, 600, 900 RPM |
| Operating Temperature | -20°C to +50°C (-4°F to +122°F) |
| IP Rating | IP67 |
| Type | Dual Grade Laser Level |
| Accuracy | ±1.5 mm at 30 m (±1/16 inch at 100 ft) |
| Laser Type | 635 nm |
| Power Source | Rechargeable NiMH batteries or alkaline batteries |
Learn how to charge and use Ni-MH and alkaline batteries for the laser.
Details on powering and operating the RC602 remote control for the laser system.
Instructions for powering the RC602 radio remote control on and off.
Steps to power the laser unit on and off, and initial checks.
Overview of the laser's standard features and display elements.
Explains the standard features of the GL622/GL612 laser system and its remote.
Guide to entering grade values using Step and Go or Digit Select methods.
How to use rotation speed settings and manual tilt adjustments.
Accessing and navigating special menu features for setup and functions.
Describes menu options available for horizontal and vertical setups.
How to activate and use the PlaneLok mode for beam locking.
How to activate and use Grade Match to measure existing grade values.
How to automatically align the laser axis to a direction hub.
How to activate standby mode and perform a reference check.
How to access and navigate the main settings menu for the laser.
Access GL/RC information, calibration procedures, and RF connectivity.
Details on special features like Line Scan for vertical setups.
Instructions for pairing the remote control and receiver with the laser.
How to set up mask sectors to turn off the beam in specific areas.
How to enter and select the desired grade display mode.
How to select sensitivity levels and configure HI-alert settings.
Settings for user name, password protection, and radio channel selection.
Procedure to check the horizontal calibration accuracy of the laser.
Procedure to check the vertical calibration accuracy of the laser.
Guidelines for protecting the unit from extreme temperatures and damage.
Instructions for cleaning laser parts and the unit housing.
Information on recycling the unit, accessories, and packaging.
Detailed technical specifications for the GL622/GL612 laser.
Detailed technical specifications for the RC602 remote control.
