Spectra Tape Series - Unpacking and Moving the Library

Chapter 3 — Installation Preparation Unpacking and Moving the Library
September 2022 Site Preperation Guide—Spectra T200, T380, and T680 Library
23
UNPACKING AND MOVING THE LIBRARY
Before moving the library to its installation location, be sure that there is
enough space at that location to remove the library from its packaging and
unpack the boxes containing the additional components. Allow the
following clearances on each side and the top of the library crates for
maneuvering while unpacking the library:
 Spectra T200 or T380—Allow 4 feet (1.2 meters) on each side and the
top of the boxes.
 Spectra T680—Allow 10 to 15 feet (3 meters to 4.6 meters) on the ramp
side of the pallet to unload the library, and 4 feet (1.2 meters) on each
side and the top to remove the packaging.
The following requirements are necessary to protect the library and
component boxes when moving them from storage to their operating
location.
Warning
The T200 library weighs approximately 230 lb (104 kg), the T380 library weighs
approximately 305 lb (138 kg), and the T680 weighs approximately 765 lb (347 kg)
without controllers, drives, and media installed. Use extreme caution when moving it.
Warnung: Die Library T200 wiegt ca. 104 kg, die Library T380 wiegt ca. 138 kg, und
die Library T680 wiegt ca. 347 kg ohne Controller, Laufwerke und Medien installiert
werden. Verwenden Sie extreme Vorsicht walten lassen, wenn sie abwandern.
Warning
The T200/T380 library is very heavy. Always use four people, two on each side,
when lifting or moving the library.
Warnung: Die T200/T380 Library ist sehr schwer. Benutzen Sie immer vier
Personen, zwei auf jeder Seite, beim Heben oder Fortbewegen der Library.
Caution
The library and components should be kept in their shipping boxes while moving
them to the installation location. If space for moving or unpacking the boxes is not
available, contact Spectra Logic Professional Services for guidance.
Caution
Be cautious when moving the library and component shipping boxes. Use a pallet
jack to move the boxes on a level surface. Use a stair crawler or other special
equipment that can handle the weight of the boxes to traverse stairways. Such
equipment must be able to transport at least 1000 lb (454 kg).