Spectra Tape Series - Page 29

Chapter 3 — Installation Preparation Updating, Servicing, or Moving the Library
September 2022 Site Preperation Guide—Spectra T200, T380, and T680 Library
29
Servicing the Library
In the event that it is necessary to replace a component, make sure that you
have instructions for performing the procedure and you either:
 Have been instructed to do so by Spectra Logic Technical Support,
—or—
 Have a support contract such as Assisted Self-Maintenance (ASM).
Moving the Library
The library hardware is configured to ensure proper thermal control, air
flow, and dust filtering. After the library is installed, do not move the
library. Do not remove the doors from the back of the library or any library
components (except the TeraPack magazines).
Important
Moving the library without assistance from a Spectra Certified Field Engineer will
void your service contract. Contact Spectra Logic Technical Support for assistance if
you need to relocate your library (see Contacting Spectra Logic on page 6).