Spectra Tape Series - Page 36

Chapter 4 — Library Specifications Library Specifications
September 2022 Site Preperation Guide—Spectra T200, T380, and T680 Library
36
Power Cord Specifications
The power cords included with the library are considered part of the
library and are not intended for use with any other equipment. See Supply-
End Connector Types on page 37 for the different types of cords available
from Spectra Logic.
Notes:  Install the included cord locks to prevent the power cords
from being inadvertently disconnected from the AC input
connectors. If the male connector does not have a twist lock,
an additional grounding wire from the chassis to earth
ground is required. For instructions on installing cord locks
and the grounding wire, see the Spectra T200, T380, and T680
Library User Guide.
 The supply-end connector is considered the disconnect for
the unit. Make sure that the socket-outlet for the AC
connections is in an accessible location near the library.
 To use the library outside of North America, the power cord
must meet the specifications for that country, as described in
the following sections. If the male connector does not have a
twist lock, an additional grounding wire from the chassis to
earth ground is required.
100–130 VAC Power Cord for Use in North America The criteria for a
100-volt to 130-volt AC power cord in North America are as follows:
North America and Korea 200–240 VAC Power Cord The criteria for a
200-volt to 240-volt AC power cord in North America and Korea are as
follows:
Warning
Risk of electrical shock. If you operate the library without locks on both ends of the
AC power cords, a permanent grounding wire must be installed between the power
supply bay and Earth ground.
Parameter Specification
Power cordage Three-conductor, 14 AWG
Power input connectors  Male: NEMA 5-15P
 Female: IEC 60320-C19
Parameter Specification
Power cordage SJT type, three-conductor, 14 AWG minimum
Power input connectors  Male: Connector must be of the proper type,
rating, and safety approval (see Supply-End
Connector Types on page 37).
 Female: IEC 60320 C13