37
Steps to configure WAN connection settings:
1. From the navigation panel, go to Advanced > Network > WAN > Internet.
2. WAN Connection Type: Choose the Internet Service Provider type. There are 5 options:
DHCP, PPPoE, Static, PPTP and L2TP. If you are unsure which type to select, please
consult your ISP.
3. MTU:
4. Connect to DNS Server:
5. Get WAN IP Automatically:
6. IP Address:
7. Subnet Mask:
8. Default Gateway:
9. DNS 1 & DNS 2:
10. Authentication:
11. Username:
12. Password:
13. PPTP Options:
14.
Access Concentrator Name:
15. Additional Pppd Options:
16. Host Name:
17. MAC Address:
To fix this issue, you can do either of the following:
·
Contact your ISP and request to update the MAC address associated with your ISP
subscription.
·
Clone or change the MAC address of the new device to match the MAC address of the
original device.
Maximum Transmission Unit value, which defines the
maximum length of a packet.
Lets WiFi Router get IP address from the DNS Server
automatically. DNS Server is a host on the Internet that
translates Internet names to numeric IP addresses.
Select Yes to get WAN IP automatically and No to enter IP
manually below.
If your WAN connection requires a static IP address, key in the
IP address in this field.
If your WAN connection requires a static IP address, key in the
subnet mask in this field.
If your WAN connection requires a static IP address, type in
the gateway IP address in this field.
Either of them indicates an IP address of a DNS server.
Use 802.1x MD5 authentication or not (IEEE 802.1x is an IEEE
Standard for port-based Network Access Control).
Username for 802.1x MD5 authentication.
Password for 802.1x MD5 authentication.
PPTP Encryption method. Select Auto for automatic Microsoft
Point-to-Point Encryption (MPPE) and select No Encryption
to disable MPPE. Select MPPE 40 for 40-bit MPPE with PPTP
Server and select MPPE 128 for 128-bit MPPE with PPTP
Server.
Specifies the Access Concentrator to connect to. If unset,
pppd uses the first discovered one.
Additional command line arguments to pass to the pppd
daemon.
This field lets you provide a host name for your WiFi Router. It
is usually provided by ISP.
MAC address identifies a device in the network. ISPs monitor
the MAC addresses of devices that connect to their services,
and would disallow Internet connection for new MAC
addresses.
To Next Page
Loading...
Need help?
General
