1.3.2 Rear Panel
There are Ethernet and USB connections and buttons shown in the following figure.
·
Factory Reset (pinhole):
·
WPS Button:
·
Ethernet (LAN) Port:
·
Internet (WAN) Port:
·
USB (3.0) Port:
·
Power:
5
Figure 3. WiFi Router rear panel
Press the pinhole and hold over 5 seconds, the WiFi Router will
reset to factory.
Push the button more than 1 second to activate WPS. Reference
2.3.2 WPS Setup.
Connect Ethernet cables for LAN (local area network)
connections, e.g. network switch, hub, personal computer or
Internet devices.
Connect Ethernet cable for WAN (Wide Area Network)
connection to modem. This connects the Ethernet and other
access lines e.g. modem.
Connect a USB Printer, U-Disk or USB drive. For printer and
folder sharing, reference 2.3.6 Services.
Use the bundled AC adapter to connect your WiFi Router to a
power source.
To Next Page
Loading...
