Spectrum 802.11ac Wave 2 User Manual

2.3.3 LAN Setup
This module makes it easier for administrator to modify the default LAN IP Address.
17
Steps to modify LAN IP settings:
1. From the navigation panel, go to Basic > Router.
2. LAN IP:
3. Subnet Mask:
4. DHCP Server:
NOTE: It’s recommended for administrator to select DHCP Server for LAN IP setting. If not,
administrator has to assign IP address to LAN-side device manually.
5. Click Apply.
The LAN IP address of the WiFi Router. Its default value is 192.168.1.1. In
IP-based networks, packets are sent to the network devices' specific IP
addresses.
Subnet mask of WiFi Router. Its default value is 255.255.255.0
DHCP (Dynamic Host Configuration Protocol) is mostly used to allocate
IP address for LAN-side devices. And a DHCP server can inform LAN-side
devices of DNS server’s address, default gateway IP and etc. This WiFi
Router can allocate 253 IP addresses at most.

Spectrum 802.11ac Wave 2 Specifications

General

Brand	Spectrum
Model	802.11ac Wave 2
Category	Network Router
Language	English