Spektrum DX6I - Binding

18 41&,536.%9Jt3"%*0130(3"..*/((6*%&
#*/%*/(
The AR6200 receiver must be bound to the transmitter before it will operate. Binding is the process of teaching the
receiver the specific code of the transmitter so it will connect to that specific transmitter. Once bound, the receiver
will only connect to the transmitter when the previously bound model memory is selected. If another model
memory is selected, the receiver will not connect. This feature is called ModelMatch
™
and prevents flying a model
using the wrong model memory.
1. With the system hooked up as shown, insert the bind plug in the charge plug receptacle.
2. Turn on the receiver switch (not included). Note that the LEDs on both receivers should be flashing,
indicating that the receiver is ready to bind.