Spektrum DX6I - General Information; Programming Using the Roller; To Access the Main Screen

78
41&,536.%9Jt3"%*0130(3"..*/((6*%&
(&/&3"-*/'03."5*0/
5)3055-&"-5
The Throttle ALT function makes the throttle stick trim active only when the throttle stick is at less than half throttle.
This allows accurate idle adjustments without affecting the mid to high throttle position.
-08#"55&3:"-"3.
When the battery voltage drops below 4.3 volts an alarm will sound and the voltage bar will flash.
8"3/*/(4$3&&/'035)3055-&)0-%456/5.0%&
When the DX6i is operated in the helicopter mode, there is a warning system that is employed to avoid hot starts
(accidental high throttle startups) when the power switch is initially turned ON. If the flight mode switch or throttle
hold is on, an alarm will sound and a warning message will be displayed on the LCD. When all switches are
returned to the normal condition, the display will return to normal.
53"*/&3
The DX6i offers a Trainer function that allows the transmitter to operate as a master or slave. The trainer switch is
located on the back left of the transmitter.
MASTER
The transmitter can be used as a master but the slave transmitter must have the same programming (i.e. reverse,
travel adjust, dual rates, mixes, sub trims, etc.) as the master.
4-"7&.0%&$0/7&/5*0/"-
When using the transmitter as a slave with another DX6i it’s necessary to match all the programmable settings (i.e.
reverse, travel adjust, etc.).
130(3"..*/(64*/(5)&30--&3
The roller is used to access all programming functions:
t 1SFTTJOHBOESFMFBTJOHUIFSPMMFSBDDFTTFTFOUFSTUIFTFMFDUFEGVODUJPO
t 3PMMJOHUIFSPMMFSDIBOHFEWBMVFTPSTFMFDUJPOT
50"$$&445)&."*/4$3&&/
Anytime the transmitter is turned on the main screen will appear.
503&563/505)&."*/4$3&&/
From the SETUP LIST or SETUP LIST screens, pressing and holding the roller for more than three seconds then
releasing the roller will return the display to the main screen.
503&563/505)&-*45034&5614$3&&/
From any program function screen, pressing and holding the roller for more than three seconds then releasing the
roller will return the display to the LIST or SETUP screen.