Spektrum NX10 User Manual

47SPEKTRUM NX10 • TRANSMITTER INSTRUCTION MANUAL
EN
The Motor Cut menu option enables you to assign a switch position
to stop the motor. Motor Cut activates regardless of Flight Mode.
When you activate Motor Cut, the ALT channel moves to the pre-
programmed position (normally Off).
You may need to use a negative value to move the ALT channel to
the off position.
CAUTION: Always test the model after making
adjustments to make sure the model responds to
controls as desired.
You can use the Motor Curve menu option to optimize the throttle
response. A maximum of 7 points are available on the throttle curve.
To add points to a Motor Curve:
1. Move the throttle stick to the position where you wish to add
the new point.
2. Scroll to Add Pt. and press the scroll wheel to add the point.
To remove points from a Motor Curve:
1. Move the motor stick until the cursor is near the point you
wish to remove.
2. Scroll to Remove Pt. and press the scroll wheel once to
remove the point.
If you program multiple throttle curves and you wish to edit one of
the curves, that curve must be active in the Motor Curve screen
before you can make any changes.
Motor Cut
Motor Curve

Spektrum NX10 Specifications

General

Modulation	DSM2, DSMX
Proper use	Airplane, Helicopter, Multirotor, Aircraft
Control type	Buttons
Product type	Remote control
Rubber grips	Yes
Product color	Black
Frequency band	2.4 GHz
Channels quantity	10 channels
Brand compatibility	Spektrum
Connectivity technology	Wired & Wireless
Number of memory records	250
Display diagonal	3.2 \
Display resolution	320 x 240 pixels
Battery voltage	3.7 V
Battery capacity	6000 mAh