14
2.8 Alarm / error display messages
These are shown on a screen in the run mode. This screen is normally hidden and will only
appear if there's a problem. Alarm and error messages are prioritized, so if there are two
active problems, clearing the first will immediately cause the lower priority one to appear.
Some, such as the power-fail error message, can be cleared by pressing and holding the
button for three seconds. Others, such as a sensor error or a commissioning errorwill need
further action to clear them. See Section 9 – 'Fault finding'.
2.9 Equipment delivery, handling and storage
Factory shipment
The product is tested, calibrated and inspected prior to shipment to ensure proper operation.
Receipt of shipment
Each carton should be inspected at the time of delivery for possible external damage. Any
visible damage should be recorded immediately on the carrier's copy of the delivery slip.
Each carton should be unpacked carefully and its contents checked for damage. If it is found
that some items have been damaged or are missing, notify Spirax Sarco immediately and
provide full details. In addition, damage must be reported to the carrier with a request for
their on-site inspection of the damaged item and its shipping carton.
Storage
If the product is to be stored for a period prior to installation, the environmental storage
conditions should be at a temperature between 0 °C and 65 °C (32 °F and 149 °F), and
between 10% and 90% relative humidity (non-condensing).
Ensure there is no condensation within the unit before installing and connecting the power.
Operators instructions
An alternative operator instruction manual, in place of this manual, for operating the equipment
is required. This will avoid the commissioning menu passcode being disclosed to the operator.
The alarm reset passcode may optionally be disclosed if this is deemed necessary.
To Next Page
Loading...
Need help?
General
