Spirax Sarco SX80 - Page 19

IM-P323-32
CTLS Issue 5
19
SX80 and SX90 Quickstart Guide
Descriptions
1
Beacons
ALM Alarm active (Red)
OP1 Lit when output 1 is ON - heat or raise
OP2 Lit when output 2 is ON - cool or lower
OP3 Not used
OP4
SPX Alternative Set Point in use (SP2 or SP3)
REM Remote Set Point or communications active
RUN Soft start timer running
'RUN' Flashing - Soft start timer in hold
MAN Manual mode selected
2 - Units (if congured)
3 - Measured value (Temperature or Pressure)
4
- Target temperature or pressure (Set Point) by
default
5
- Meter (SX90 only) defaults to valve position if
the quick code 2 is D, V or B.
Defaults to Heat/Cool (centre zero) if quick
code 2 is A or H.
6 - Operator buttons