Spirent Tech-X Flex - Setup - Connect (Wi-Fi Setup)

Tech-X Flex™ Base Unit User Guide Issue 1
2: Wi-Fi Testing Menu 2-7
Intro
Wi-Fi
10/100
System
IP/Video
Specs
Once the unit successfully connects, the network parameters are saved in memory under the respective
SSID (name).
NOTE: If you have trouble connecting, see If you cannot connect (troubleshooting tips) on page 2-3.
Setup - Connect (Wi-Fi Setup)
Table 2-1 Connect (Wi-Fi Setup) - Setup parameters page 1
Parameter Description
SSID (Service Set Identifier) Network name.
Channel Number Channel used by the network, typically 1 to 11 with variances possible based on the
country of operation and applicable regulations. A Wi-Fi connection is based on a
single channel which you must have correctly specified.
Network Type Type of network:
INFRASTRUCTURE - A centralized network where the unit will negotiate with a
single access point that manages the network overall.
NOTE: Connection to “adhoc” Wi-Fi networks is currently not supported.
Security Type Type of security in use on the network:
• WEP-64 - Wired Equivalent Privacy using a 40-bit key.
• WEP-128 - Wired Equivalent Privacy using a 104-bit key.
• NONE - No security (open access)