Spirent Tech-X Flex - Wi-Fi Setup > View Auto-Connect Networks; IP Network Setup; Ping

Base Unit User Guide Issue 1 Tech-X Flex™
2-10 2: Wi-Fi Testing Menu
Intro
Wi-Fi
10/100
System
IP/Video
Specs
2.3.4 Wi-Fi Setup > View Auto-Connect Networks
This function displays the current list of auto-connect networks. You can use the Delete shortcut to
remove the selected network from the list. For more information, see About the connection history and
“auto-connect” networks on page 2-4.
2.4 IP Network Setup
IP Network Setup allows you to assign IP routing information to the unit in order to perform IP-based
testing. This function operates similarly to other interfaces; however, note that when launched from the
Wi-Fi menu, the assigned IP information applies to the wireless interface/connection only.
For more information on IP Network Setup parameters and results, see IP Network Setup on page 5-1.
NOTE: The unit must have an active wireless connection before IP Network setup is available (see Wi-
Fi Setup on page 2-5).
2.5 Ping
Ping testing over the Wi-Fi interface is similar to other interfaces. For more information, see Ping on
page 5-4.
Security Type of security in use by the network:
• NONE - No security (open access)
• WEP - Wired Equivalent Privacy
Signal Strength Signal power level.
Channel Number Channel used by the network, typically 1 to 11 with variances possible based on
the country of operation and applicable regulations. A Wi-Fi connection is based
on a single channel which you must have correctly specified when attempting to
connect.
Auto-connect Indicates whether the network is on the auto-connect list (see About the
connection history and “auto-connect” networks on page 2-4).
Table 2-4 Details (Wi-Fi Setup) - Results
Result Description